Scan Tool Data List

2006 Buick Terraza CXL, 3.5 L, AWDSECTION Scan Tool Data List
WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
Electronic Brake Control Module (EBCM)

Ignition is ON, engine OFF, and vehicle is stationary.
Scan Tool Parameter Data List Units Displayed Typical Data Value
ABS Active ABS Data Yes/No No
ABS Failed ABS Data Yes/No No
Battery Voltage Signal ABS/TCS Data Volts Varies
BPP Signal ABS Data Released/Applied Released
Brake Fluid Level Status ABS Data OK/Low OK
Delivered Torque TCS Data % Varies
DRP Active ABS Data Yes/No No
DRP Disabled ABS Data Yes/No No
Engine Drag Control Failed ABS Data Yes/No No
Left Front Wheel Speed ABS/TCS Data km/h or mph 0
Left Rear Wheel Speed ABS/TCS Data km/h or mph 0
LF Inlet Valve Solenoid ABS Data On/Off Off
LF Outlet Valve Solenoid ABS Data On/Off Off
LR Inlet Valve Solenoid ABS Data On/Off Off
LR Outlet Valve Solenoid ABS Data On/Off Off
Panic Brake Assist Failed ABS Data No/Yes No
Pump Motor Commanded Voltage ABS/TCS Data Volts Varies
Requested Torque TCS Data % Varies
Right Front Wheel Speed ABS/TCS Data km/h or mph 0
Right Rear Wheel Speed ABS/TCS Data km/h or mph 0
RF Inlet Valve Solenoid ABS Data On/Off Off
RF Outlet Valve Solenoid ABS Data On/Off Off
RR Inlet Valve Solenoid ABS Data Active/Inactive Off
RR Outlet Valve Solenoid ABS Data On/Off Off
TCS Active TCS Data Yes/No No
TCS Failed TCS Data Yes/No No
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.