Installation Procedure

2006 Buick Terraza CXL, 3.5 L, AWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Drain Cock
    GM1272787Courtesy of GENERAL MOTORS CORP.
  1. Install the seal on the drain cock stem.
  2. Install the drain cock. Make sure that the body is fully seated in the side tank of the radiator.
  3. Screw the radiator drain cock in to the radiator.
  4. Fill the cooling system. Refer to Draining and Filling Cooling System (LS4 Static Fill)Β  or Draining and Filling Cooling System (LZE, LZ4, LZ9 Static Fill)Β  or Draining and Filling Cooling System (9C1, 9C3 Static Fill)Β  or Draining and Filling Cooling System (LS4 GE 47716 Fill)Β  or Draining and Filling Cooling System (LZE, LZ4, LZ9, 9C1, 9C3 GE 4771 Fill)Β .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.