Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSBUICK2006TERRAZA CXL, 3.5 L, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 199 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM)REPAIR INSTRUCTIONSINFLATABLE RESTRAINT SIDE IMPACT MODULE WIRING HARNESS REPLACEMENTREMOVAL PROCEDURE

2006 Buick Terraza CXL, 3.5 L, AWD

Removal Procedure

2006 Buick Terraza CXL, 3.5 L, AWDSECTION Removal Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Refer to SIR Inflator Module Handling and Storage Caution .

Disable the SIR system. Refer to SIR Disabling and Enabling Zone 7 or SIR Disabling and Enabling Zone 9 (Monte Carlo) or SIR Disabling and Enabling Zone 9 (Impala) .
Remove the side impact inflator module from the seat. Refer to Inflatable Restraint Side Impact Module Replacement - Front (Monte Carlo) .

Fig 1: Inflatable Restraint Side Impact Module Wiring Harness At Seat Frame With Retaining Clips

Courtesy of GENERAL MOTORS CORP.

With the seat back cover in the open position the wiring harness on the side impact inflator module will be exposed.
Remove the retaining clips that secure the inflator module wiring harness to the seat.
Remove the wiring harness.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.