Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2006TERRAZA CXL, 3.5 L, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 199 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC B1370CIRCUIT/SYSTEM TESTING
2006 Buick Terraza CXL, 3.5 L, AWD
Circuit/System Testing
2006 Buick Terraza CXL, 3.5 L, AWDSECTION Circuit/System Testing
WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
When removing connectors inspect for damage or corrosion. Damage or corrosion in the following requires repair or replacement of the affected component/connector.
- The SDM module
- The SDM wiring harness connector
- Ignition OFF, remove the Air Bag fuse from the underhood fuse center. Ignition ON, engine OFF test the voltage from the supply voltage side of the AIR BAG fuse to a ground with a DMM. The voltage should read 9-16 volts.
- If the voltage is less than 9-16 volts, correct the open or short on the voltage supply circuit or the open in the control side of the RUN/CRANK relay.
- Remove the SDM connector. With the air bag fuse removed, test the ignition 1 voltage circuit between the underhood fuse center and the SDM for a short to voltage or an open. Verify that a short to voltage or an open does not exist.
- If any of the above conditions are found, make the appropriate repair.
- If ignition 1 voltage circuit test normal then refer to Diagnostic Aids within this repair.
- If all circuits test normal, replace the SDM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.