Wiper Arm Blade Replacement

2006 Buick Terraza CXL, 3.5 L, AWDSECTION Wiper Arm Blade Replacement
WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Replacing Wiper Arm Blade
GM1596268Courtesy of GENERAL MOTORS CORP.
Wiper Arm Blade Replacement

Callout Component Name
Fastener Tightening Specifications:Β  Refer to Fastener Tightening SpecificationsΒ .

Preliminary Procedures

  1. Open the hood.
  2. Raise the wiper blade off the glass.
1 Retention Clip, Windshield Wiper Blade
Tip:Β  Lift the locking tab away from the wiper arm hook in order to disengage the wiper arm from the wiper blade.
2 Blade, Windshield Wiper Arm
3 Hook, Wiper Arm Sheep
Tip:Β  Push the wiper blade assembly onto the hook, pull the blade outward then secure the locking tab to the arm assembly.
4 Arm Assembly, Windshield Wiper
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.