Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2006 Buick Terraza CXL, 3.5 L, AWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
- Install the fuel tank fill pipe.
- Install the fuel tank fill pipe hose (2) onto the fuel tank (3)
- Connect the vent pipe quick connect fitting to the fuel tank vent pipe quick connect fitting. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .NOTE: Refer to Fastener Notice .
- Tighten the fuel fill pipe clamp (1) at the fuel tank.
Tighten: Tighten the clamp to 2.5 N.m (22 lb in).
- Install the EVAP line (2) to the bracket (3).
- Install the fill pipe bracket bolt (4) to the underbody rail.
Tighten: Tighten the bolt to 13 N.m (115 lb in).
- Lower the vehicle.
- Install the fuel fill pipe screws to the fuel filler pocket.
Tighten: Tighten the screws to 2.5 N.m (22 lb in).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.