SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2006TERRAZA CXL, 3.5 L, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 18 (ENGINE CONTROL SYSTEM - 3.6L (LY7) - INTRODUCTION (2 OF 2))REPAIR INSTRUCTIONSCAMSHAFT POSITION (CMP) SENSOR REPLACEMENT - BANK 2 (LEFT) INTAKEINSTALLATION PROCEDURE
2006 Buick Terraza CXL, 3.5 L, AWD

Installation Procedure

2006 Buick Terraza CXL, 3.5 L, AWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Left CMP Sensor - Intake
    GM1285241Courtesy of GENERAL MOTORS CORP.
  1. Install the CMP sensor.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the CMP sensor bolt.

    Tighten:  Tighten the CMP sensor bolt to 10 N.m (89 lb in).

    3. Fig 2: View Of Left CMP Sensor Electrical Connector - Intake
    GM1285239Courtesy of GENERAL MOTORS CORP.
  3. Install the CMP sensor electrical connector.
  4. Install the power steering fluid reservoir. Refer to Remote Power Steering Fluid Reservoir Replacement in Power Steering System.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.