Scan Tool Data List

2006 Buick Terraza CXL, 3.5 L, AWDSECTION Scan Tool Data List
WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
Radio

Scan Tool Parameter Data List Units Displayed Typical Data Value
Operating Conditions: Ignition ON/Engine OFF/Radio ON
Antenna Module Data Enabled/Disabled Enabled
Auxiliary Video Input Data Present/Not Present Not Present
Battery Voltage Signal Data Volts 11.8 Volts
CD H/W Level CD/DVD/MAP Information Numeric Varies
CD S/W Level CD/DVD/MAP Information Numeric Varies
DVD H/W Part Number CD/DVD/MAP Information Numeric Varies
DVD S/W Part Number CD/DVD/MAP Information Numeric Varies
Navigation Software Version CD/DVD/MAP Information Numeric Varies
Navigation Hardware Level CD/DVD/MAP Information Numeric Varies
Component Serial No. 13 - 16 Module Information Numeric Varies
End Model Part Number Module Information Numeric Varies
Base Model Part Number Module Information Numeric Varies
DRR Data Present/Not Present Present
Ign. Cycles Since Last DTC Data Numeric Varies
Software Part Number Module Information Numeric Varies
Year Module Built Module Information Numeric Varies
Julian Date of Build Module Information Numeric Varies
Phone Signal Data Present/Not Present Present
Power Mode Data Off/Accessory/Run/Crank Request Varies
Power Mode Config. Data Normal Mode/Bench Mode Normal Mode
Signal Strength Data dBuV 19 dBuv
Video Display Data Present/Not Present Not Present
Theft Armed Data Learned VIN/No VIN Learned VIN
Theft Lock Status Data Active/Inactive Inactive
Digital Radio Receiver

Scan Tool Parameter Data List Units Displayed Typical Data Value
Operating Conditions: Ignition ON/Engine OFF/Radio ON
Battery Voltage Data Volts 12.2 Volts
Digital Radio Antenna Data mV 1400 mV
Ignition Counter Data Numeric 98
Julian Date of Build Module Information Numeric 043
Power Mode Data Run/Crank/
Accessory/
RAP/Off Awake
Run
Year Module Built Module Information Numeric varies
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.