Installation Procedure

2006 Buick Terraza CXL, 3.5 L, AWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Headlamp Flasher Components
    GM803390Courtesy of GENERAL MOTORS CORP.
  1. Position the headlamp flasher (1) to the front radiator support (2).
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the headlamp flasher bolts.

    Tighten:Β  Tighten the bolts to 10 N.m (89 lb in).

  3. Connect the electrical connectors.
  4. Install the upper radiator baffle. Refer to Radiator Air Baffle and Deflector Replacement - Upper in Engine Cooling.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.