Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2006TERRAZA CXL, 3.5 L, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 17 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM)REPAIR INSTRUCTIONSREPAIRS AND INSPECTIONS REQUIRED AFTER A COLLISIONFRONTAL INFLATOR MODULE DEPLOYMENT
2006 Buick Terraza CXL, 3.5 L, AWD
Frontal Inflator Module Deployment
2006 Buick Terraza CXL, 3.5 L, AWDSECTION Frontal Inflator Module Deployment
WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
After a collision involving air bag deployment, replace the following components.
- Inflatable restraint instrument panel (I/P) module
- Inflatable restraint steering wheel module
- Inflatable restraint sensing and diagnostic module (SDM)
- Inflatable restraint front end sensor, left/right
- Inflatable restraint seat belt pretensioners
Perform additional inspections on the following components.
- Steering wheel module coil and the coil wiring pigtail-Inspect for melting, scorching, or other damage due to excessive heat.
- Mounting points or mounting hardware for the I/P, steering wheel module, SDM, and pretensioners-Inspect for any damage and repair or replace each component as needed.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.