Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit Description
Correct engine misfire detection is dependent on whether or not the vehicle is experiencing a rough road condition. A rough road condition causes unexpected crankshaft fluctuations. In order to detect a rough road condition, the electronic brake control module (EBCM) communicates a wheel speed signal over the serial data circuit to the engine control module (ECM). The wheel speed sensor information allows the ECM to distinguish if the crankshaft speed variations are caused by a rough road condition or are caused by a true misfire. If the EBCM reports a wheel speed sensor failure or the ECM does not receive the rough road information, this DTC sets.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.