Installation Procedure

2006 Buick Terraza CXL, 3.5 L, AWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Front Seat Back Heater Element & Electrical Connector
    GM1466651Courtesy of GENERAL MOTORS CORP.
  1. Peel off the self-stick tape from the heater element.
  2. Position the heater element over the seat back. Press firmly to engage the adhesive.
  3. Route and connect the electrical connector to the seat back cushion. Secure the wire with tie straps.
  4. Install the seat back cover. Refer to Seat Back Cover Replacement - FrontΒ .
  5. Install the front seat. Refer to Seat Replacement - Front BucketΒ .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.