Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2006TERRAZA CXL, 3.5 L, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 13 (SEAT SYSTEM)REPAIR INSTRUCTIONSSEAT BACK FRAME REPLACEMENT - REAR
2006 Buick Terraza CXL, 3.5 L, AWD
Seat Back Frame Replacement - Rear
2006 Buick Terraza CXL, 3.5 L, AWDSECTION Seat Back Frame Replacement - Rear
WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
Seat Back Frame Replacement - Rear
| Callout | Component Name |
|---|---|
|
NOTE:
Refer to Fastener Notice
in Cautions and Notices. Fastener Tightening Specifications:
Refer to Fastener Tightening Specifications .Preliminary Procedure: Remove the rear seat back. Refer to Seat Back Replacement - Rear (Non-folding) or Seat Back Replacement - Rear (Folding) . |
|
| 1 | Nuts, Seat Back Armrest (Qty: 4) |
| 2 | Armrest Assembly, Rear Seat Tighten: 10 N.m (88 lb in) |
| 3 | Bolt/Screw, Rear Seat Back Bolster (Qty: 4) Tighten: 4 N.m (35 lb in) |
| 4 | Panel, Rear Seat Back Bolster Cushion |
| 5 | Cover, Seat Back Bolster |
| 6 | Pad, Seat Back Bolster Tip: Remove the hog rings that attach the seat cushion cover to the seat cushion. |
| 7 | Bolt/Screw, Rear Seat Back Cushion Tighten: 25 N.m (18 lb ft) |
| 8 | Pad Assembly, Rear Seat Back |
| 9 | Cover Assembly, Rear Seat Back Cushion |
| 10 | Panel, Rear Seat Back Cushion |
| 11 | Panel, Rear Seat Back Cushion |
| 12 | Frame Assembly, Rear Seat Back |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.