Removal Procedure

2006 Buick Terraza CXL, 3.5 L, AWDSECTION Removal Procedure
WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (L26)Β  or Battery Negative Cable Disconnect/Connect Procedure (LY7)Β .
  2. Fig 1: View Of Battery Positive & Negative Cables
    GM772424Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the battery positive cable from the battery.
  4. Fig 2: Identifying Battery Tray & Bolt
    GM772403Courtesy of GENERAL MOTORS CORP.
  5. Remove the battery retainer bolt and battery retainer.
  6. Remove the battery from the vehicle.
  7. Remove the battery heat shield. Refer to CELL LINKΒ  .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.