Removal Procedure

2006 Buick Terraza CXL, 3.5 L, AWDSECTION Removal Procedure
WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wiper drive system module. Refer to Wiper Drive System Module ReplacementΒ .
  2. Fig 1: Removing/Installing Wiper Crank Arm & Nut
    GM1257438Courtesy of GENERAL MOTORS CORP.
  3. Remove the wiper crank arm nut (2) from the wiper motor shaft.
  4. Remove the wiper crank arm (1) from the wiper motor shaft.
  5. Fig 2: Removing/Installing Wiper Motor & Screws
    GM815221Courtesy of GENERAL MOTORS CORP.
  6. Remove the wiper motor screws from the wiper motor.
  7. Remove the wiper motor from the wiper module.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.