Installation Procedure

2006 Buick Terraza CXL, 3.5 L, AWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Washer Hose
    GM815215Courtesy of GENERAL MOTORS CORP.
  1. Position the washer hose to the vehicle.
  2. Route the washer pump hose down along side the right front inner fender and into the front inner fender area.
  3. Connect the washer hose to the air inlet grille panel.
  4. Fig 2: View Of Washer Hose At Wiper Arms
    GM815210Courtesy of GENERAL MOTORS CORP.
  5. Connect the washer hose to the wiper arms.
  6. Fig 3: View Of Washer Hose & Washer Pump
    GM815217Courtesy of GENERAL MOTORS CORP.
  7. Raise the vehicle.
  8. Connect the washer hose to the washer pump.
  9. Install the right front fender liner. Refer to Fender, Fender Insulator, Wheelhouse Liner Replacement - Front in Body Front End.
  10. Close the hood.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.