Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2006TERRAZA CXL, 3.5 L, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 109 (PERSONALIZATION SYSTEMS)DESCRIPTION AND OPERATIONVEHICLE PERSONALIZATIONPROGRAMMING FEATURESENTER PROGRAMMING MODELOCK SWITCH ARM (IF EQUIPPED WITH THEFT DETERRENT)
2006 Buick Terraza CXL, 3.5 L, AWD
Lock Switch Arm (if equipped with Theft Deterrent)
2006 Buick Terraza CXL, 3.5 L, AWDSECTION Lock Switch Arm (if equipped with Theft Deterrent)
WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
Continue with the following steps in order to personalize the content Key Cylinder Disarm options:
- Scroll through the menu, using the Options button, until Theft Deterrent is displayed. If Theft Deterrent is programmed to ON, this feature will be programmable.
- Press the Set/Reset button to enter the menu and to scroll through the following options.
- OFF
- ON
- If ON is selected, the content theft deterrent system will arm when the doors are locked with the door lock switch. The key must be removed from the ignition to when the doors are locked or the theft system will not arm.
- Press the Options button again in order to set the desired selection and to move to the next feature.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.