Installation Procedure

2006 Buick Terraza CXL, 3.5 L, AWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Center Seat Power Cable & Front Hook Attachments
    GM1368199Courtesy of GENERAL MOTORS CORP.
  1. Position the center seat in the vehicle.
  2. Insert front hook attachments (2) into the floorpan.
  3. Connect the power port electrical cable (1) on the right side of the seat.
  4. Install the two front bucket seats. Refer to Seat Replacement - Front BucketΒ .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.