SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2006TERRAZA CXL, 3.5 L, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 106 (SEAT SYSTEM)REPAIR INSTRUCTIONSDRIVE CABLE REPLACEMENT - VERTICALREMOVAL PROCEDURE
2006 Buick Terraza CXL, 3.5 L, AWD

Removal Procedure

2006 Buick Terraza CXL, 3.5 L, AWDSECTION Removal Procedure
WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Front Seat Bolts
    GM305124Courtesy of GENERAL MOTORS CORP.
  1. Remove the front bolts.
  2. Tip the seat forward and disconnect the electrical connector from the seat electrical harness.
  3. Disengage the seat hook attachments from the floor pan.
    4. Fig 2: Identifying Vertical Drive Cables & Motor
    GM964716Courtesy of GENERAL MOTORS CORP.
  4. Tip the seat forward to expose the vertical drive cables (3 or 4).
  5. To remove either cable perform the following procedure:
    1. Bend the flexible cable at the center.
    2. Pull the cable out of the motor (1 or 2) and the drive screw.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.