Removal Procedure

2006 Buick Terraza CXL, 3.5 L, AWDSECTION Removal Procedure
WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air cleaner intake duct. Refer to Air Cleaner Intake Duct ReplacementΒ .
  2. Fig 1: Identifying MAF/IAT Sensor
    GM1208107Courtesy of GENERAL MOTORS CORP.
  3. Unclip the retaining fasteners (4) on the air cleaner cover.
  4. Remove the air cleaner cover.
  5. Fig 2: View Of Air Cleaner Element
    GM1207827Courtesy of GENERAL MOTORS CORP.
  6. Remove the air cleaner element (1) from the air cleaner housing (2).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.