Removal Procedure

2006 Buick Terraza CXL, 3.5 L, AWDSECTION Removal Procedure
WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Coaxial Cable Navigation Antenna
    GM1204254Courtesy of GENERAL MOTORS CORP.
  1. Remove the rear shelf trim panel. Refer to Trim Panel Replacement - Rear Window Shelf in Interior Trim.
  2. Reposition the sound barrier for access.
  3. Use a small wide-bladed plastic tool to release the adhesive. Remove the navigation antenna (2) from the rear shelf.
  4. Disconnect the navigation antenna cable connector.
  5. Clean the adhesive residue from the rear shelf using a razor blade, an isopropyl alcohol pad, and a clean lint-free cloth.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.