Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSBUICK2006TERRAZA CXL, 3.5 L, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEEXTERIOR BODY PANELSBODY FRONT ENDREPAIR INSTRUCTIONSFENDER REPLACEMENT - FRONT

2006 Buick Terraza CXL, 3.5 L, AWD

Fender Replacement - Front

2006 Buick Terraza CXL, 3.5 L, AWDSECTION Fender Replacement - Front

Fig 1: Replacing Front Fender

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: Refer to Fastener Notice . Fastener Tightening Specifications: Refer to Fastener Tightening Specifications . Preliminary Procedures Remove the hood hinge. Refer to Hood Hinge Replacement . Remove the front wheelhouse liner. Refer to Wheelhouse Liner Replacement - Front . Remove the headlamp. Remove the antenna on passenger fender. Refer to Fixed Antenna Replacement .
1	Bolt, Front Fender Upper (Qty: 4) Tighten: 8 N.m (71 lb in)
2	Bolt, Front Fender Rear (Qty: 3) Tighten: 8 N.m (71 lb in)
3	Bolt, Front Fender Lower Rear Tip: Reposition the rocker panel molding to gain access to the bolt. Tighten: 8 N.m (71 lb in)
4	Bolt, Front Fender Lower Front Tighten: 8 N.m (71 lb in)
5	Bolt, Front Fender Upper Front Tighten: 6 N.m (53 lb in)
6	Nut, Front Fender Front Lower Bracket (Qty: 2) Tip: Loosen the nut enough to allow the fender to slide out of the slots. Tighten: 6 N.m (53 lb in)
7	Fender Assembly, Front

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.