Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2006RENDEZVOUS FWD V6-3.5L VIN LREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGTESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURESSCAN TOOL TESTING - HVAC SYSTEM - MANUALSCAN TOOL DATA DEFINITIONS
2006 Buick Rendezvous FWD V6-3.5L VIN L
Scan Tool Data Definitions
2006 Buick Rendezvous FWD V6-3.5L VIN LSECTION Scan Tool Data Definitions
SCAN TOOL DATA DEFINITIONS
8 Digit GM Part Number : The scan tool displays the part number for service identification.
A/C High Side Pressure: The scan tool displays -103 to +3119 kPa (-14 to +452 psi). This parameter represents the air conditioning (A/C) refrigerant pressure sensor voltage signal converted to pressure.
A/C High Side Pressure: The scan tool displays 0.00-5.00 Volts. This parameter represents the A/C refrigerant pressure sensor signal.
A/C Off For WOT: The scan tool displays Yes or No. Yes indicates that the powertrain control module (PCM) or engine control module (ECM) has disabled the A/C compressor because the TP sensor signal is at wide open throttle.
A/C Pressure Disable: The scan tool displays Yes or No. Yes indicates that the PCM/ECM has disabled the A/C compressor due to excessive refrigerant pressure.
A/C Relay Circuit Status: The scan tool displays OK or Fault. This parameter indicates the state of the driver circuit for this device.
A/C Relay Command: The scan tool displays On or Off. Represents the PCM/ECM commanded state of the A/C compressor clutch relay control circuit. The A/C compressor clutch should be engaged when Commanded A/C displays On.
A/C Request Signal: The scan tool displays Yes or No. The PCM/ECM uses the A/C request signal in order to determine if A/C compressor operation is being requested by the BCM.
A/C Switch: The scan tool displays Active or Inactive. Displays the state of the A/C request signal circuit from the HVAC control module to the BCM.
ECT Sensor: The scan tool range is -39°C to +140°C (-38°F to +284°F). Displays the temperature of the engine coolant.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.