SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2006ALLURE CXSREPAIR AND DIAGNOSISRESTRAINTSAIR BAG, SRSSUPPLEMENTAL INFLATABLE RESTRAINT SYSTEMREPAIR INSTRUCTIONSINFLATABLE RESTRAINT STEERING WHEEL MODULE COIL REPLACEMENT
2006 Buick Allure CXS

Inflatable Restraint Steering Wheel Module Coil Replacement

2006 Buick Allure CXSSECTION Inflatable Restraint Steering Wheel Module Coil Replacement
Fig 1: View Of Inflatable Restraint Steering Wheel Module Coil Components
GM1545329Courtesy of GENERAL MOTORS CORP.
Inflatable Restraint Steering Wheel Module Coil Replacement

Callout Component Name
Fastener Tightening Specifications:  Refer to Fastener Tightening Specifications .

Preliminary Procedures

  1. Disable the supplementary inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling Zone 3 .
  2. Remove the steering wheel. Refer to Steering Wheel Replacement .
  3. Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement (Manual Tilt) .
1 Connectors, Coil to Steering Column Harness.
Tip:  Remove the wire harness straps from the steering wheel column wire harness.
2 Ring, Retaining (Qty: 1)
Tip:  When installing the retaining ring 1, ensure that the retaining ring is firmly seated in the groove 2 on the steering column shaft.
3 Coil, SIR
NOTE: The new SIR coil assembly will be centered. Improper alignment of the SIR coil assembly may damage the unit, causing an inflatable restraint malfunction.

Tip: 
  1. Ensure that the SIR coil is centered before removing it.
  2. When installing the SIR coil, ensure that the turn signal cancel cam assembly and the SIR coil are aligned.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.