Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2006 Buick Allure CXSSECTION Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Install the lower AIR pump bolts/nuts.
- Install the upper AIR pump.
Tighten: Tighten the upper and lower AIR pump to cradle bolts to 9 N.m (80 lb in).
- Reconnect the AIR pump electrical connector.
- Install the AIR outlet hose and pinch clamp to the AIR pump (2).
- Install the AIR inlet hose to the AIR pump (2).
NOTE:
Refer to FASTENER NOTICE
Cautions and Notices.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.