Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
2006 Buick Allure CXSSECTION Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (L26) or Battery Negative Cable Disconnect/Connect Procedure (LY7) in Engine Electrical.
- Remove the 14-way electrical connector from the ignition control module (ICM).
- Disconnect the spark plug wires from the coil assemblies. Before removing the wires, note the position of the wires.
- Remove the ICM nuts (2).
- Remove the ICM (1) from the bracket.
- Remove the ignition coil screws (1).
- Remove the ignition coils (2) from the ICM (3).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.