Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2005RENDEZVOUS AWD V6-3.6L VIN 7REPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINAUTOMATIC TRANSMISSION/TRANSAXLESERVICE AND REPAIROVERHAUL54. REVERSE INPUT CLUTCH DISASSEMBLE
2005 Buick Rendezvous AWD V6-3.6L VIN 7
54. Reverse Input Clutch Disassemble
2005 Buick Rendezvous AWD V6-3.6L VIN 7SECTION 54. Reverse Input Clutch Disassemble
Reverse Input Clutch Disassemble
^ Tools Required
- J 23327-1 Forward Clutch Spring Compressor (Bridge)
- J 25018-A Clutch Spring Compressor Adapter
1. Remove the reverse input clutch retaining ring (614).
2. Remove all reverse input clutch plates (611-613).
3. Install the J 23327-1 and the J 25018-A.
4. Compress the reverse input clutch spring assembly.
5. Remove the reverse input clutch spring retainer ring (610).
6. Remove the reverse input clutch spring assembly (609).
7. Remove the reverse input clutch piston assembly (607).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.