Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2005RENDEZVOUS AWD V6-3.6L VIN 7REPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINAUTOMATIC TRANSMISSION/TRANSAXLECONTROL MODULESERVICE AND REPAIR
2005 Buick Rendezvous AWD V6-3.6L VIN 7
Control Module: Service and Repair
2005 Buick Rendezvous AWD V6-3.6L VIN 7SECTION Service and Repair
Module, Transmission Control - Replace
Removal Procedure
1. Turn the ignition OFF.
2. Remove the air cleaner upper cover.
3. Remove the transmission control module from the air cleaner.
4. Disconnect the transmission control module electrical connectors from the transmission control module.
Installation Procedure
1. Connect the transmission control module electrical connectors to the transmission control module.
2. Install the transmission control module to the air cleaner.
3. Install the air cleaner upper cover.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.