Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2005RENDEZVOUS AWD V6-3.6L VIN 7REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSDATA LINK CONNECTORSERVICE AND REPAIR
2005 Buick Rendezvous AWD V6-3.6L VIN 7
Data Link Connector: Service and Repair
2005 Buick Rendezvous AWD V6-3.6L VIN 7SECTION Service and Repair
DATA LINK CONNECTOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the bolts/screws from the data link connector.
2. Remove the lower data link connector.
INSTALLATION PROCEDURE
1. Place the data link connector into position.
2. Install the bolts/screws to the data link connector.
Tighten the bolts/screws to 2 N.m (18 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.