Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2005LESABRE LIMITED, 4T65E/M15REPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS - INTRODUCTIONREPAIR INSTRUCTIONSIGNITION CONTROL MODULE REPLACEMENTINSTALLATION PROCEDURE
2005 Buick LeSabre Limited, 4T65E/M15
Installation Procedure
2005 Buick LeSabre Limited, 4T65E/M15SECTION Installation Procedure
- Attach the coils (2) and the ignition control module (3) to the bracket.
- Install the screws (1) that retain the ignition coils (2) and the ICM (3) to the bracket.
Tighten: Tighten the screws to 4.5 N.m (40 lb in).
- Connect the spark plug wires.
- Connect the 14-way connector to the module.
Tighten: Tighten the screw to 2.1 N.m (19 lb in).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.