Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSBUICK2005LESABRE LIMITED, 4T65E/M15REPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS - INTRODUCTIONREPAIR INSTRUCTIONSEXHAUST GAS RECIRCULATION (EGR) OUTLET PIPE REPLACEMENTREMOVAL PROCEDURE

2005 Buick LeSabre Limited, 4T65E/M15

Removal Procedure

2005 Buick LeSabre Limited, 4T65E/M15SECTION Removal Procedure

Fig 1: Removing/Installing EGR Valve Outlet Pipe

Courtesy of GENERAL MOTORS CORP.

Remove the bolt (3) that attaches the EGR outlet pipe flange to the intake manifold.
Remove the nut (2) that attaches the EGR outlet pipe to the EGR valve inlet pipe assembly.
Remove the EGR valve outlet pipe (1).

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.