Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2005LESABRE LIMITED, 4T65E/M15REPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS - INTRODUCTIONREPAIR INSTRUCTIONSENGINE COOLANT TEMPERATURE (ECT) SENSOR REPLACEMENTREMOVAL PROCEDURE
2005 Buick LeSabre Limited, 4T65E/M15
Removal Procedure
2005 Buick LeSabre Limited, 4T65E/M15SECTION Removal Procedure
IMPORTANT:
Use care when handling the coolant sensor. Damage to the sensor will effect proper operation of the fuel control system.
- Turn OFF the ignition.
- Drain the coolant below the level of the engine coolant temperature (ECT) sensor. Refer to Draining and Filling Cooling System in Engine Coolant.
- Disconnect the sensor electrical connector.
- Carefully remove the ECT sensor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.