SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2005LESABRE LIMITED, 4T65E/M15REPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS - INTRODUCTIONREPAIR INSTRUCTIONSACCELERATOR CONTROLS CABLE REPLACEMENTREMOVAL PROCEDURE
2005 Buick LeSabre Limited, 4T65E/M15

Removal Procedure

2005 Buick LeSabre Limited, 4T65E/M15SECTION Removal Procedure
  1. Remove the left closeout/insulator panel. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages and Console.
    2. Fig 1: Removing/Installing Accelerator Control Cable At Accelerator Pedal Lever
    GM65171Courtesy of GENERAL MOTORS CORP.
  2. Remove the accelerator control cable (1) from the accelerator pedal (2) lever.
    3. Fig 2: Removing/Installing Accelerator Control Cable Through Bulkhead
    GM65179Courtesy of GENERAL MOTORS CORP.
  3. Squeeze the accelerator cable cover tangs and push the accelerator cable (1) through the bulkhead.
    4. Fig 3: Removing/Installing Accelerator Control Cable At Right Slot Top Of Washer Bottle
    GM65183Courtesy of GENERAL MOTORS CORP.
  4. Remove the accelerator control cable (1) from the retaining clip (2).
  5. Remove the accelerator control cable (1) from the right slot on top of washer bottle (3).
    6. Fig 4: Removing/Installing Accelerator Control Cable At Accelerator Control Bracket & Throttle Body Lever
    GM179148Courtesy of GENERAL MOTORS CORP.
  6. Remove the accelerator cable (2) from the throttle body lever (3).
    7. Fig 5: Removing/Installing Accelerator Control Cable At accelerator cable bracket
    GM179152Courtesy of GENERAL MOTORS CORP.
  7. Remove the accelerator cable (1) from the accelerator control cable bracket (2).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.