Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSBUICK2005LESABRE LIMITED, 4T65E/M15REPAIR AND DIAGNOSISBODY & FRAMEWINDOWSSTATIONARY WINDOW SYSTEMREPAIR INSTRUCTIONSWINDSHIELD REPLACEMENTREMOVAL PROCEDURE

2005 Buick LeSabre Limited, 4T65E/M15

Removal Procedure

2005 Buick LeSabre Limited, 4T65E/M15SECTION Removal Procedure

IMPORTANT: Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and the interior trim.

Open the hood.
Remove the windshield wiper arms. Refer to Wiper Arm Replacement in Wipers/Washer Systems.
Remove the air inlet grille. Refer to Air Inlet Grille Panel Replacement in Body Front End.

CAUTION: If broken glass falls into the defroster outlets, it can be blown into the passenger compartment and cause personal injury.

Cover to protect the following parts from broken glass:
- Upper dash pad
- Defroster outlets and A/C outlets
- Seats and carpeting
Remove the windshield reveal molding. Refer to Urethane Adhesive Installation of Stationary Windows .
Remove the rearview mirror. Refer to Rearview Mirror Replacement (DD7) or Rearview Mirror Replacement (UE1) .
Remove the rain sensor. Refer to Windshield Outside Moisture Sensor Replacement in Wipers/Washer Systems.
Remove the windshield garnish moldings. Refer to Garnish Molding Replacement - Windshield Pillar in Interior Trim.

Fig 1: Identifying Windshield Reveal Molding

Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.