Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSBUICK2005LESABRE LIMITED, 4T65E/M15REPAIR AND DIAGNOSISBODY & FRAMESEATSSEAT SYSTEMREPAIR INSTRUCTIONSSEAT REPLACEMENT - SPLIT BENCHINSTALLATION PROCEDURE

2005 Buick LeSabre Limited, 4T65E/M15

Installation Procedure

2005 Buick LeSabre Limited, 4T65E/M15SECTION Installation Procedure

Fig 1: View of Center Belt on AM6 Drivers Seat

Courtesy of GENERAL MOTORS CORP.

Position the front seat in the vehicle.
Install the center seat belt on the AM6 drivers seat. Refer to Seat Belt Replacement - Center Front in Seat Belts.
Connect the electrical connector on the six-way power seat.

Fig 2: View Of Seat Track Fasteners

Courtesy of GENERAL MOTORS CORP.

Install the rearward front seat fasteners.
Tighten: Tighten the fasteners to 30 N.m (22 lb ft).

Fig 3: View of Forward Front Seat Fasteners

Courtesy of GENERAL MOTORS CORP.

Place the seat to the full rearward position.
Install the forward front seat fasteners.
Tighten: Tighten the fasteners to 30 N.m (22 lb ft).

Fig 4: View of Front Seat At Full Rearward Position

Courtesy of GENERAL MOTORS CORP.

Install the front seat fastener trim covers.
Return the front seat to its original position.
Enable the SIR system. Refer to SIR Disabling and Enabling Zone 7 and SIR Disabling and Enabling Zone 9 in SIR.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.