Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSBUICK2005LESABRE LIMITED, 4T65E/M15REPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESANTILOCK BRAKE SYSTEM, TRACTION CONTROL SYSTEM & STABILITY CONTROL SYSTEMREPAIR INSTRUCTIONSELECTRONIC BRAKE CONTROL MODULE REPLACEMENTINSTALLATION PROCEDURE

2005 Buick LeSabre Limited, 4T65E/M15

Installation Procedure

2005 Buick LeSabre Limited, 4T65E/M15SECTION Installation Procedure

Fig 1: View Of Both halves Of EBCM

GM458834

Courtesy of GENERAL MOTORS CORP.

Clean the seal surface of the BPMV.
Install the EBCM (2) to the BPMV (1).

Fig 2: Disassembling/Reassembling Electronic Brake Control Module

GM458840

Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.