SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2005LESABRE LIMITED, 4T65E/M15REPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMESEATSSEAT SYSTEMREPAIR INSTRUCTIONSSEAT CUSHION REPLACEMENT - FRONTREMOVAL PROCEDURE
2005 Buick LeSabre Limited, 4T65E/M15

Removal Procedure

2005 Buick LeSabre Limited, 4T65E/M15SECTION Removal Procedure
  1. Disable the SIR System. Refer to SIR Disabling and Enabling Zone 7 or SIR Disabling and Enabling Zone 9 in SIR.
    2. Fig 1: View of Seat Cushion Fasteners
    GM670423Courtesy of GENERAL MOTORS CORP.
  2. Move the seat to the full forward position.
  3. Remove the fasteners (1) securing the seat cushion to the seat adjuster assembly.
  4. Lift the front of the seat cushion upwards.
  5. Remove the power seat switches. Refer to Seat Switch Replacement - Power .
    6. NOTE: Refer to Electrical Wiring Routing Notice in Cautions and Notices.
  6. Disconnect the wiring harness fastener and retainers securing the wiring harness to the bottom of the seat cushion frame.
  7. Remove the memory seat module from the seat cushion frame, if equipped. Refer to Memory Seat Control Module Replacement .
  8. Pull the cushion forward in order to remove the seat cushion from the seat adjuster assembly.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.