Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSBUICK2005LESABRE LIMITED, 4T65E/M15REPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMESEATSSEAT SYSTEMREPAIR INSTRUCTIONSMEMORY SEAT CONTROL MODULE REPLACEMENTINSTALLATION PROCEDURE

2005 Buick LeSabre Limited, 4T65E/M15

Installation Procedure

2005 Buick LeSabre Limited, 4T65E/M15SECTION Installation Procedure

Position the memory seat module to the bottom of the seat cushion.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the memory seat module fasteners.
Tighten: Tighten the fasteners to 2 N.m (18 lb in).

Fig 1: View of Memory Seat Module

Courtesy of GENERAL MOTORS CORP.

Install the electrical connectors to the memory seat module.
Ensure the wiring harness is positioned in the original location.
Install the seat cushion. Refer to Seat Cushion Replacement - Front .
Enable the SIR system. Refer to SIR Disabling and Enabling Zone 7 in SIR.
Calibrate the seat. Refer to Memory Seat Calibration Procedure .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.