SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2005LESABRE LIMITED, 4T65E/M15REPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCRUISE CONTROL SYSTEMSREPAIR INSTRUCTIONSCRUISE CONTROL MODULE REPLACEMENTINSTALLATION PROCEDURE
2005 Buick LeSabre Limited, 4T65E/M15

Installation Procedure

2005 Buick LeSabre Limited, 4T65E/M15SECTION Installation Procedure
    Fig 1: View of Cruise Control Module & Bracket Assembly
    GM428993Courtesy of GENERAL MOTORS CORP.
  1. Install the cruise control module (2) to the bracket.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the module to bracket fasteners.

    Tighten:  Tighten the fasteners to 7.5 N.m (66 lb in).

  3. Install the cruise control module and bracket assembly to the vehicle.
  4. Install the module retaining fasteners (1, 3).

    Tighten:  Tighten the fasteners to 9 N.m (80 lb in).

    5. Fig 2: View of Electrical Connector
    GM428990Courtesy of GENERAL MOTORS CORP.
  5. Connect the electrical connector (2).
    6. IMPORTANT: The cruise control cable does not require mechanical adjusting after the replacement. The cruise control module internally adjusts the cable. Refer to Cruise Control Description and Operation  for the complete operational details.
  6. Connect the cruise control cable. Refer to Cruise Control Cable Replacement .
  7. Inspect the component operation.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.