SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2004RAINIER AWD V8-5.3L VIN PREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTRELAYS AND MODULES - POWERTRAIN MANAGEMENTRELAYS AND MODULES - COMPUTERS AND CONTROL SYSTEMSBODY CONTROL MODULESERVICE AND REPAIRMODULE REAR BODY CONTROL REPLACEMENT - ENDGATE
2004 Buick Rainier AWD V8-5.3L VIN P

Module Rear Body Control Replacement - Endgate

2004 Buick Rainier AWD V8-5.3L VIN PSECTION Module Rear Body Control Replacement - Endgate


Module Rear Body Control Replacement - Endgate

Removal Procedure

1. Remove the trim panel from the end gate.




2. Remove the screws (2) retaining the rear body control module (BCM) (1) to the end gate.
3. Disconnect the electrical connectors from the rear BCM.
4. Remove the module from the vehicle.

Installation Procedure




1. Install the rear BCM (1) to the end gate.
2. Connect the electrical connectors to the module.

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the screws (2) retaining the rear BCM to the end gate.

Tighten the rear BCM screws to 2.5 N.m (22 lb in).

4. Install the trim panel to the end gate.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.