Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2004RAINIER AWD V8-5.3L VIN PREPAIR AND DIAGNOSISBODY AND FRAMESEATSSEAT BACKSERVICE AND REPAIRSEAT BACK LATCH BRACKET - REAR
2004 Buick Rainier AWD V8-5.3L VIN P
Seat Back Latch Bracket - Rear
2004 Buick Rainier AWD V8-5.3L VIN PSECTION Seat Back Latch Bracket - Rear
Seat Back Latch Bracket - Rear
Removal Procedure
1. Remove the seat back from the vehicle.
2. Remove the bolts (2) that retain the latch bracket to the seat hinge.
3. Remove the latch bracket from the seat hinge.
Installation Procedure
1. Position the latch bracket to the seat hinge.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the latch bracket bolts (2) that retain the latch bracket to the seat hinge.
Tighten the latch bracket bolts to 35 N.m (26 lb ft).
3. Install the seat back to the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.