Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2000REGAL V6-3.8L SC VIN 1PARTS AND LABORENGINE, COOLING AND EXHAUSTENGINELABOR TIMES
2000 Buick Regal V6-3.8L SC VIN 1
Engine: Labor Times
2000 Buick Regal V6-3.8L SC VIN 1SECTION Labor Times
| Standard Hours | Manufacturer Warranty Hours | Skill Level | Notes | |
| Diagnose/Test | ||||
| Oil Leak, Diagnosis | 1.0 | 0.0 | B | |
| Replace | ||||
| Complete Assembly With Transfer of Parts | 12.3 | 8.1 | B | Includes: Transfer All Fuel & Electrical Units. Does Not Include Transfer Of Optional Equipment. |
| Complete Assembly Without Transfer Of Parts | 9.8 | 6.8 | B | Does Not Include: Transfer Of Any Part Of Engine Or Replacement Of Optional Equipment. |
| Long Block | 16.3 | 0.0 | B | Includes: R&I Engine And Transfer All Necessary Components Not Supplied With Long Block. |
| NOTE | ||||
| With Air, Add | 0.5 | 0.0 | B | |
| Short Block | 19.3 | 0.0 | A | Includes: R&I Engine & Transfer All Necessary Parts. |
| NOTE | ||||
| To Grind Valves, Add | 1.6 | 0.0 | A | |
| With Air, Add | 0.5 | 0.0 | A | |
| Overhaul/Rebuild | 29.3 | 0.0 | A | Includes: Measure Cylinder Bores, Crankshaft & Pistons For Proper Size & Hone Cylinders. Renew Pistons. Rings. Pins. Main & Rod Bearings, Grind Valves & Tune-Up. |
| NOTE | ||||
| With Air, Add | 0.5 | 0.0 | A |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.