Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2000 Buick Regal GSSECTION Installation Procedure
- Install the thermostat.
- Install the gasket and the water outlet housing.
- Install the water outlet housing bolts.
Tighten:
Tighten the bolts to 27 N.m (20 ft lbs)
- Install the radiator hose to the water outlet housing. Use the J 38185 to reposition and install the hose clamp to the water outlet housing.
- Install the air cleaner intake duct.
- Fill the cooling system. Refer to Draining and Filling Cooling System
- Install the fuel injector sight shield.
- Inspect for leaks.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.