Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2000PARK AVENUE BASE, 3.8 KREPAIR AND DIAGNOSISBODY & FRAMEMIRRORSPOWER MIRROR SYSTEMTROUBLE SHOOTINGSYSTEM OPERATION CHECK
2000 Buick Park Avenue Base, 3.8 K
System Operation Check
2000 Buick Park Avenue Base, 3.8 KSECTION System Operation Check
- Move mirror select switch to left mirror position. Operate left mirror to left, right, up and down positions. Mirror should operate as commanded in all positions.
- Move mirror select switch to right mirror position. Operate right mirror to left, right, up and down positions. Mirror should operate as commanded in all positions.
- If vehicle is equipped with memory mirror option, press memory No. 1 button. A single beep should be heard and both mirrors should move to positions programmed for memory No. 1 button. Press memory No. 2 button. A single beep should be heard and both mirrors should move to positions programmed for memory No. 2 button.
- If vehicle is equipped with parallel park mirror option, turn ignition switch to ON position. Move shift lever to Reverse. Right mirror should tilt downward approximately 7 degrees, or to end of travel. If mirror system does not function properly, repair by symptom. See SYMPTOM INDEX table under SYMPTOM TESTS.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.