SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2000PARK AVENUE BASE, 3.8 1REPAIR AND DIAGNOSIS (SINGLE PAGE)GENERAL INFORMATIONCOMPUTER RELEARN PROCEDURESRELEARN PROCEDURES (CARS)CENTURY, GRAND PRIX, INTRIGUE, LUMINA, MONTE CARLO & REGALPASSLOCK(TM) 30 MINUTE RELEARN PROCEDURE (IMPALA & MONTE CARLO)
2000 Buick Park Avenue Base, 3.8 1

PASSLOCK(TM) 30 Minute Relearn Procedure (Impala & Monte Carlo)

2000 Buick Park Avenue Base, 3.8 1SECTION PASSLOCK(TM) 30 Minute Relearn Procedure (Impala & Monte Carlo)
  1. Clear all DTCs. See scan tool manufacturer's instructions. Turn ignition off. Replace component(s) as necessary.
  2. With transmission in Park (A/T) or Neutral (M/T), turn ignition switch momentarily to START position (DO NOT start engine). Leave ignition switch in RUN position (engine off). After 10 minutes, when SECURITY light turns off, turn ignition switch to OFF position for 5 seconds.
  3. Repeat step 2) twice more. Turn ignition switch to OFF position. Auto learn procedure will be completed during next start attempt. Clear all DTCs.
NOTE: New module can only be programmed once. Verify customer's code prior to programming to ensure key code is correct.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.