Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2000PARK AVENUE BASE, 3.8 1REPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSREMOTE KEYLESS ENTRY SYSTEMSPROGRAMMING PROCEDURESPROGRAMMING TRANSMITTERS
2000 Buick Park Avenue Base, 3.8 1
Programming Transmitters
2000 Buick Park Avenue Base, 3.8 1SECTION Programming Transmitters
NOTE:
All RKE transmitters which are to be recognized by the RFA must be programmed in a single programming sequence. If RFA is placed in program mode, all previously programmed transmitters will be erased upon receipt of the programming signal from the first transmitter.
- Connect scan tool. Ignition on, engine off. Use scan tool REMOTE FUNCTION ACTUATION SPECIAL FUNCTION: PROGRAM KEY FOBS to place RFA in PROGRAM MODE. The doors will lock and then unlock to confirm program mode.
- Press and hold LOCK button and UNLOCK button simultaneously on one transmitter. After a 15 second delay, doors will lock and unlock to confirm programming of that transmitter.
- Program up to 4 RKE transmitters by repeating previous step. When all RKE transmitters are programmed, remove scan tool. Operate transmitter functions in order to verify correct system operation.
NOTE:
Scan tool must stay connected until all transmitters are programmed.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.