Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2000PARK AVENUE BASE, 3.8 1REPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSANTI-THEFT SYSTEMPROGRAMMINGPASS-KEY(R) III SYSTEM QUICK LEARN PROCEDURE
2000 Buick Park Avenue Base, 3.8 1
Pass-Key(R) III System Quick Learn Procedure
2000 Buick Park Avenue Base, 3.8 1SECTION Pass-Key(R) III System Quick Learn Procedure
NOTE:
PASS-Key(R) III system quick learn procedure is used to learn additional ignition keys (Black master or Gray valet). A learned Black master key must be used to initiate procedure. Up to 10 ignition keys can be learned.
- Insert a valid master ignition key in the ignition switch. Turn ignition on, engine off. After 10 seconds, turn ignition off and remove key.
- Within 10 seconds, insert new valid mechanical code of unlearned key and turn ignition switch to RUN position. SECURITY indicator light will illuminate until key is learned. This may happen so quickly light illumination is not observed. Turn ignition off. Key is now learned. To learn additional keys, repeat this step.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.