Electrical Component Locator: Connectors

1999 Buick Regal LSSECTION Connectors
CONNECTORS LOCATION

Component Location
C101 (Gray, 20 Pin) On left strut tower.
C105 (Gray, 4 Pin) On radiator.
C111 (7 Pin) On top of transaxle.
C113 (Gray, 20 Pin) On top of transaxle.
C141 (Black, 10 Pin) Behind left headlamp.
C142 (Black, 10 Pin) Behind right headlamp.
C200 (Black, 56 Pin) Behind right side of dash. See Figure .
C201 (Black, 17 Pin) On right side of steering column. See Figure .
C205 (Black, 4 Pin) On right side of steering column.
C206 (Black, 3 Pin) Behind right side of dash.
C240 (Natural, 10 Pin) Behind console shift.
C242 (Black, 3 Pin) Behind ashtray.
C250 (8 Pin) Behind center of dash.
C252 (32 Pin) Behind center of dash.
C301 (Black, 32 Pin) On left "A" pillar.
C302 (16 Pin) On right "A" pillar.
C311 (Black, 6 Pin) Below driver seat.
C312 (Black, 6 Pin) Below passenger seat.
C351 (Black, 6 Pin) On left "B" pillar.
C352 (Black, 6 Pin) On right "B" pillar.
C380 (10 Pin) Below rear of console assembly.
C390 (Black, 8 Pin) On top of shelf panel.
C395 (Black, 2 Pin) Under right side of rear shelf trim panel.
C398 (Black, 3 Pin) On right "C" pillar.
C401 (Gray, 6 Pin) Behind taillamp.
C402 (Gray, 6 Pin) Behind taillamp.
C405 (Black, 8 Pin) Forward of spare wheelwell.
C410 (Black, 8 Pin) Above right wheelwell.
C420 (Blue, 2 Pin) Under center of rear window trim panel.
C915 (Black, 4 Pin) On center of rear compartment lid applique.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.