Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK1998REGAL 25TH ANNIVERSARY EDITIONREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSKEYLESS ENTRY SYSTEM - REMOTEPROGRAMMING PROCEDURESREMOTE LOCK CONTROL CUSTOMIZATIONWITHOUT SCAN TOOL
1998 Buick Regal 25th Anniversary Edition
Without Scan Tool
1998 Buick Regal 25th Anniversary EditionSECTION Without Scan Tool
- Sit in driver's seat. Close all vehicle doors. Turn ignition to RUN position.
- Depress and hold door lock switch to LOCK position. Depress transmitter LOCK button. Chime will sound 1-4 times, equal to current customization mode. Each addition time LOCK button is depressed, mode number will advance, repeating back to mode one from mode four. See REMOTE LOCK/UNLOCK VERIFICATION CUSTOMIZATION table.
- Release door lock switch from LOCK position when desired mode has been indicated by chime. Turn ignition off. Verify system operation.
REMOTE LOCK/UNLOCK VERIFICATION CUSTOMIZATION
| Mode | Lock/Unlock Customization |
|---|---|
| 1 | Disabled |
| 2 | Horn Only |
| 3 | Headlights Only |
| 4 | Horn & Headlights |
NOTE:
GM Tech 2 scan tool or equivalent scan tool may be used to program Remote Lock verification. Follow screen prompts and instructions.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.