Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Driven Sprocket Support Assembly: Installation
Use petroleum jelly to secure housing thrust washer for 2nd clutch to driven sprocket support assembly. Finger tighten 2 channel plate bolts (13 mm) into driven sprocket support assembly. Using bolts, lift driven sprocket support into transaxle case. See Figure. Top of support should be flush with case. If support is not flush with case, one of the clutches is not fully seated.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.